Satchboogie3
10-13-2007, 05:54 AM
I'm trying to make a sorta recreation of TTD/Kingda Ka and I'm having trouble with the top hat. I can't find any supports (beams) that will fit right. I'm specifically looking for medium thick beams (like the ones used in steelworks for TTD) that are verticle and have a middle-side placement (centered middle on the side of the tile) to connect up with the /\ created at the tophat.
http://i21.tinypic.com/9anwie.jpg
So for #1, as I said it needs to be one edge of the tile, but centered (not corner).
For #2, I can't find an angled beam that is place on the edge of the tile.
For #3, again, horizontal piece with a middle-side placement.
If have a ton of CS packs but I can't find anything that would work. Do any of you guys know of a pack/piece(s) that would work?
http://i21.tinypic.com/9anwie.jpg
So for #1, as I said it needs to be one edge of the tile, but centered (not corner).
For #2, I can't find an angled beam that is place on the edge of the tile.
For #3, again, horizontal piece with a middle-side placement.
If have a ton of CS packs but I can't find anything that would work. Do any of you guys know of a pack/piece(s) that would work?